Industry up to date

Technology for forestry, agricultural and construction machinery

Novotechnik0919SPS hall 4A, booth 125

For position detection directly in the pressure range of hydraulic or pneumatic cylinders Novotechnik The displacement transducers of the new TM1 series have been developed. They reliably measure the position and speed of mobile machines even in harsh environmental conditions with a resolution of 0,1 mm.

The successors of the TIM series are suitable for measuring lengths up to 2000 mm and are optimized for use in applications with the highest EMC requirements. They comply with the EN 13309 for construction equipment and the ISO 14982 for agricultural and forestry machinery, are protected against 11452 V / m according to ISO 2-200 and thus exceed the E1 requirements of the German Federal Motor Vehicle Office. The measuring signal can be output as an analog current or voltage signal or via fieldbus interfaces (CAN open, CAN SAE J1939).

The IP6K9K sensors offer pressure resistance up to 350 bar, pressure peaks up to 450 bar, high temperature resistance from -40 ┬░ to + 105 ┬░ C and a very long service life thanks to the contactless, wear-free measuring principle. The connector system allows quick installation into closed or single-sided open cylinders without soldering, crimping or screwing: The contact carrier of the M12 connector is already connected to the signal lines of the sensor; it is guided through a hole in the cylinder to the outside.


Another contribution of the manufacturer This e-mail address is being protected from spambots To display JavaScript must be turned on!

This website is presented by: